ASTM C1376 Glass Pyrolytic Coatings
Things about ASTM-C1376: Pyrolytic and vacuum deposition coatings on flat glass 1.1 This specification covers the optical and aesthetic quality requirements for coatings applied to glass for use in building glazing. 1.2 The coatings covered are applied to the glass using either pyrolytic or vacuum (sputtering) deposition methods and are typically applied to control solar […]
ASTM C1375 Sealants Testing Standard
Things about ASTM-C1375: Standard guide for substrates used in testing building seals and sealants 1.1 This guide describes the recommended standard substrates and their recommended surface preparation for use in standard tests of building seals and sealants. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its […]
ASTM C1369 Insulating Glass Secondary Sealants Standard
Things about ASTM-C1369-02: standard specification for secondary edge sealants for structurally glazed insulating glass units 1.1 This specification describes the properties of cold, liquid-applied, single or multi-component, chemically curing, elastomeric sealants used as the secondary seal of sealed insulating glass units, hereinafter referred to as the “sealant” (see Fig. 1). These sealants are intended to […]
ASTM C1349 Glass Polycarbonate Standard
Things about ASTM-C1349-10: standard specification for architectural flat glass clad poolycarbonate 1.1 This specification covers the quality requirements for cut sizes of glass-clad polycarbonate (GCP) for use in buildings as security, detention, hurricane/cyclic wind-resistant, and blast and ballistic-resistant glazing applications. 1.2 Optical distortion and the evaluation thereof are not currently within the scope of the […]
ASTM C1294 Insulating Glass Sealant Compatibility Standard
Things about ASTM-C1294-01: standard test method for compatibility of insulating glass edge sealants with liquid-applied glazing materials 1.1 This test method covers a laboratory procedure for quantitatively measuring the compatibility of liquid-applied glazing materials with an insulating glass unit edge sealant. Compatibility is determined by measuring the changes in the insulating glass edge sealant adhesive […]